CONTENTSINSTALLATION GUIDE•OWNER’S GUIDETechnical AssistanceAll tech personnel are expertly qualified to answer any technical questions.Technicians ar
9LED Status IndicatorThe LED (red light) provides valuable information about the system and is also a theft deterrent.LED Status LED DisplayArmed Flas
10Lock/Unlock with Ignition OnDisarm the system and press and hold Button #3 for (10) ten seconds or until the unit chirps once. Release Button#3 then
SYSTEM FEATURES12 Long Range Four-Button Remotes Hand-held, easy to use and lets you operate the system from an extended distance.Keyless Entry with o
SYSTEM COMPONENTSTECHNICAL ASSISTANCEBEFORE YOU BEGIN2PRECAUTIONSShould you need help. First check our website at www.bulldogsecurity.com or call our
MAKING WIRING CONNECTIONS3NOTE: In most cases you should not cut your vehicle wire in two.1. Strip back two inches of insulation on the wire from the
4CAUTION: All wires must be wrapped with tape and wire tied.4. Use electrical tape to wrap, be sure to cover about 2 inches on either side of connecti
54.Connect the siren's BLACK wire to the third mounting screw, using the spade connector. Make sure thisis a solid ground.5.Connect the siren&apo
6INSTALLING THE FLASHING LED STATUS INDICATORThe LED indicator installs inside your vehicle and should be installedas high as possible and be visible
7OPTIONAL CONNECTIONSTESTING: Door LocksThere are three basic types:“Type A” Door Lock Test (Most GMs and some Chryslers)Probe both of your door lock
8WIRING DIAGRAMS8 7 6 5 4 3 2 116 15 14 13 12 11 9BLUE:WHITE:MAIN CONNECTORHOW TO USEYOUR REMOTE TRANSMITTERArmingPress Button #1 to arm the system. T
Comments to this Manuals