Bulldog Security Deluxe 62 Operations Instructions download pdf (Page 3)

System Features............................................................................3-5

System Components..........................................................................5

Technical Assistance..........................................................................6

Before You Begin...............................................................................6

Precautions.......................................................................................7

Neutral Safety Switch........................................................................8

Antenna Placement............................................................................9

Installation Diagram........................................................................10

Connecting The 18-Pin Harness ...................................................11-13

Connecting the Main power, Ignition and Accessory Wires...................13

Making Main Power, Ignition and Accessory Connections.....................14

Testing Door Locks .....................................................................15-16

Connecting Door Locks................................................................17-19

Programming Instructions ...........................................................20-23

Operating Instructions ................................................................24-26

Warranty Registration ......................................................................27

CONTENTS

DELUXE 62I

Deluxe Remote Starter with Alarm and Keyless Entry

SYSTEM FEATURES

Security System Features

2 Four-Button Extended Remotely start your car to run the heater or air conditioning from

Range Remote Transmitters an extended distance.

Remote Programmable On- Provides warn away and impact protection.

board Dual Stage Shock Sensor

Remote Programmable Allows you to adjust the shock sensor sensitivity with the remote

Sensitivity Reduction transmitter.

Active Arming This feature will only arm the alarm system with your remote

transmitter.

* When this option has been installed.

OPERATING INSTRUCTIONS

Adjusting Shock Sensor (Vehicle must be disarmed with engine off)

The on-board shock sensor can be programmed for sensitivity by holding down Button

#4 (Stop) for 5 seconds until a chirp or horn honk is heard. Release Button #4. Tap the

vehicle, directly over the alarm, at the sensitivity level you wish. The harder you hit the

vehicle, the less sensitive the alarm will be. As soon as you impact the vehicle the horn

will honk or the siren will chirp indicating that the sensitivity has been set. If you do not

tap the vehicle the sensitivity will automatically set at maximum. The shock programming

window is 5 seconds.

Minor Violation

The first time that the shock sensor is violated, the parking lights will flash three (3) times

and the horn/siren will chirp three (3) times. If the sensor is violated again within 30

seconds, the unit will go into full violation.

Zone Lockout

if any one zone is violated three (3) times consecutively, that zone will not produce another

violation for the remainder of the arm cycle.

Temporary Silent Arm/Disarm (This Arming Only)

Press and hold Button #2 for approximately two (2) seconds, the parking lights will flash

once, the unit is now programmed for Silent Arming. Release Button #2 and press again,

the parking lights will flash twice, and remain on for one (1) minute, the unit is now

Disarmed.

(1)

(2)

(4)

(3)

KEEP THIS CARD IN YOUR WALLET

Remote Starting: Press and release Button #1. The parking lights

will flash once confirming the signal was received and the vehicle

will start. Once running, the parking lights will turn on and

remain on. If start fails, the unit will make two additional attempts.

Arm/Disarm: Press and release Button #2. The parking lights will

flash once with one chirp from the siren for Arm and the doors will lock.

The parking lights will flash twice with two chirps from the siren for

Disarm and the doors will unlock.

Pit Stop: Exiting the vehicle with the engine running. Make sure the vehicle is in park. Press

Button #1 and then turn the ignition to the off position. The vehicle will remain running.

Valet Mode - On: Press and hold the brake, turn Ignition Key to the Run position. Within

five (5) seconds, press and release Button #4. The horn will sound or the siren will chirp

once, the parking lights flash once and the LED will flash once. Valet is now on. Release the

brake, turn the ignition key off. The LED will remain lit in valet mode. Valet Mode - Off:

Repeat process for Valet Mode On. The horn will sound or the siren will chirp twice, the

parking lights flash twice and the LED will flash twice. Valet is now off. Release the brake,

turn the ignition key off. The LED will now turn off.

Trunk Release: Press and release Button #3, the parking lights will flash and the trunk will

open (if installed).

1 2 3 4 5 6 7 8 ... 13 14

Comments to this Manuals

No comments

Bulldog Security Deluxe 62 Operations Instructions Page 3

Comments to this Manuals

Related products and manuals for Remote starters Bulldog Security Deluxe 62